Howdy,
I have searched for but not found any mention of what size holes are in the plastic sandwich container trap for the small hive beetle. I will be using a drill and would like to know what size bit to use. I do not want any bees getting in.
Thank you
Quote from: Gerald in Ga on August 12, 2007, 10:26:19 AM
Howdy,
plastic sandwich container trap for the small hive beetle.
what kinda trap you talking about?? never heard of a plastic sandwich trap before!!
try tillies blog and here is a thread that might be helpfull.http://forum.beemaster.com/index.php?topic=9122.0
Howdy TwT and pdmattox,
I'm talking about the one from Mrs. Tillie's blog site. She got it from a guy named Mel. Although she shows how to make it, I didn't hear any mention of the hole size.
That is what I am needing to know.
Thanks again.
Here is the direct link to the small hive beetle trap. (http://www.beeworks.com/informationcentre/small_hive_beetle.html)
reinbeau,
Thank you very much for that link. That was exactly what I was looking for.
I made one as well. Check my post that I will update immediatley after this at
http://forum.beemaster.com/index.php?topic=10811.0
I found that a traditional soldering iron pushed quickly in and out all the way through, made the perfect sided holes.
Otherwise 4.5mm.
Be careful using these traps. I tried the traps using 3/16 holes and killed bees that crawled through the holes. I took the traps out and started using checkmite to get rid of the shb. If you use the trap, dont drill the holes larger than 1/8, because bees will get through and die. Just a little info before you try the trap. seezya
A bee can get through 3/16" A bee can get through 1/6". A bee cannot get through 1/8".
Quote from: Michael Bush on September 30, 2007, 01:21:32 PM
A bee can get through 3/16" A bee can get through 1/6". A bee cannot get through 1/8".
The bees will plug the hole and to unplug it I use a hive stapel or w/e So Just heat up a staple and use that to make the holes The staple is a tight fit and the shb can get in but not the bees. My friend is the one that came up with this trap. plastic sandwich container with a lid glued in the center with the bait and oil on the out side of that
I used the tip of the soldering iron and just barely made a hole. I've only killed two bees in the traps and that was when I panicked that my holes were too small and enlarged them on one side of one trap. The holes I have are about 1/8" or a little smaller. The SHB is a little guy and gets in quite nicely. The trap works well and the sandwich container has the added advantage of having an easily removable top for dumping out the dead. There's a video on my site of making the trap and you can see the size of the holes in the video.
Linda T in Atlanta