Print Page - double nuc box/bottom board

Title: double nuc box/bottom board
Post by: Ross on April 13, 2008, 02:55:39 PM

I changed the design on my nuc bottom boards to a screened bottom. I didn't get a shot of it, but each side exits on the opposite end.

http://www.myoldtools.com/Bees/nuc/nuc1.jpg
http://www.myoldtools.com/Bees/nuc/nuc2.jpg
http://www.myoldtools.com/Bees/nuc/nuc3.jpg
http://www.myoldtools.com/Bees/nuc/nuc4.jpg
http://www.myoldtools.com/Bees/nuc/nuc5.jpg

Title: Re: double nuc box/bottom board
Post by: Jim134 on May 23, 2008, 07:28:08 AM

Looks good to me !!

Bee Good Jim 134

Title: Re: double nuc box/bottom board
Post by: Scott Derrick on May 23, 2008, 10:28:44 PM

That is sweet. I wish I was that good at woodworking. Good Job!

Title: Re: double nuc box/bottom board
Post by: Ross on May 24, 2008, 11:29:28 AM

You can do it all on the table saw with straight cuts. I did use a router to finish the ends of the groove, but I could have done it as fast with a chisel.

Beemaster's International Beekeeping Forum

BEEKEEPING LEARNING CENTER => EQUIPMENT USAGE, EXPERIMENTATION, HIVE PLANS, CONSTRUCTION TIPS AND TOOLS => Topic started by: Ross on April 13, 2008, 02:55:39 PM