anyone have a set? i need to make my hives easier it maneuver. i have a skid steer with forks and can utilize that!
sorry but plans are in my head. Mine are 33" X 45" Across the center I screw a 4" X 3/4" X 33" board. I then add a 2" X 3/4 X 33" board down the middle of this. This creates a 1" shelf facing both ways. The boxes are butted against the 2" board and holds the spacing between the backs of the hives. I then add a 2" X 3/4 X 19" board down the center of each side. These hold double clips. All that is left is 3/4 X 3/4 X 19" boards screwed down the outside edge and a entrance reducer. Boxes are set in the clips and pushed back as far as they will go
This the original
http://www.meyerhoneyfarms.com/clips.html (http://www.meyerhoneyfarms.com/clips.html)
and if you like a FAX of it
Jim,
The design you see online is a picture of the original drawing. An email of the file would look like the one on the web page. If you are willing to send me a fax number, I am happy to send you a faxed copy of the original drawing. I think a fax might give you a clearer copy of the design.
Best regards,
Melissa Shipley
Office Manager
A. H. Meyer & Sons, Inc.
(605) 485-2221
BEE HAPPY Jim 134 :)
adamant.........
And why did you not but this topic under ??
EQUIPMENT USAGE, EXPERIMENTATION, HIVE PLANS, CONSTRUCTION TIPS AND TOOLS
I believe you would get more hits.
http://forum.beemaster.com/index.php/board,19.0.html (http://forum.beemaster.com/index.php/board,19.0.html)
BEE HAPPY Jim 134 :)
Quote from: Jim 134 on May 27, 2012, 09:58:28 AM
adamant.........
And why did you not but this topic under ??
EQUIPMENT USAGE, EXPERIMENTATION, HIVE PLANS, CONSTRUCTION TIPS AND TOOLS
I believe you would get more hits.
http://forum.beemaster.com/index.php/board,19.0.html (http://forum.beemaster.com/index.php/board,19.0.html)
BEE HAPPY Jim 134 :)
good point.. most of my posts and replies are done from my cell phone and sometimes little hard to navigate