Beemaster's International Beekeeping Forum

BEEKEEPING LEARNING CENTER => GENERAL BEEKEEPING - MAIN POSTING FORUM. => Topic started by: WP4FL on December 19, 2005, 02:09:57 PM

Title: Paint inside the hive
Post by: WP4FL on December 19, 2005, 02:09:57 PM
Hello everybody, just a newbie question.
  I read that one should not paint the interior of hives, the problem is that I read it after painting my whole hive with exterior paint.

     My question: Could this cause a problem to the health of the hive?  

                              Thanks in advance.
Title: Paint inside the hive
Post by: bassman1977 on December 19, 2005, 02:20:19 PM
When the hive heats up you (and your bees) could expect fumes.  Could cause the hive to abscond or kill them, depending on the chemical composition of the paint.
Title: Paint inside the hive
Post by: Apis629 on December 19, 2005, 05:22:50 PM
I heard that the greater danger is that the paint would trap moisutre causeing a premature rot in the wood.  One thing that you could try if you haven't installed the bees yet is to sand out most of the dry paint.  Did you use a water base, oil base, or latex base paint?
Title: Paint inside the hive
Post by: Finsky on December 19, 2005, 07:01:07 PM
No idea to paint inside. It is easy to clean inside walls with flame. It need mere wood.
Title: Paint inside the hive
Post by: Colorado Beekeeper on December 19, 2005, 07:37:50 PM
well then I won't paint mine! :D
Title: Paint inside the hive
Post by: Michael Bush on December 19, 2005, 08:47:55 PM
I wouldn't paint it.  But if I had some that were recently painted, (assuming no lead in the paint)  I'd let them air out well and use them.
Title: Paint inside the hive
Post by: Finsky on December 20, 2005, 02:15:52 AM
When you clean inside wall with gas flame, resin and wax goes into wood. It gives protection what wood needs.
Title: Paint inside the hive
Post by: WP4FL on December 22, 2005, 11:25:49 PM
Quote from: Apis629Did you use a water base, oil base, or latex base paint?

          Latex Paint.

   Thanks guys for all your help, but I already have that hive working right now, so I realy do not know what to do.

                    Thanks.
Title: Paint inside the hive
Post by: Michael Bush on December 23, 2005, 12:05:17 AM
>I really don't know what to do.

Leave them alone.  :)  They'll do fine.
Title: Paint inside the hive
Post by: Finsky on December 23, 2005, 02:00:17 AM
Quote from: WP4FLso I realy do not know what to do.

Paint faintly outside with latex. It is idea that moisture from walls goes out.
Do nothing to inner walls.

I painted my wooden boxes 40 years ago. There is still same latex on outer walls.
Title: Paint inside the hive
Post by: latebee on December 23, 2005, 10:49:35 PM
Paint technology has come a long way in the past decade. I prefer some of the newer breathable stain-sealants on the market. On the other hand I have heard of some beekeepers dipping thier entire hive bodies in HOT parrafin to kill pathogens and also to preserve the wood. Recently acquired some  hive bodies that are at least 75 years old and still going strong with what appears to be minimal care! From past  experience over a few years I would definitely advise AGAINST oil based paints as they really do trap moisture in the wood and lead to premature failure of the hive body. But due to climate differences and temp extremes in your area-do as the romans do and follow the succesful beekeepers in your region. I think you will find that they paint the out side only,with whatever they prefer.
Title: Paint inside the hive
Post by: asleitch on January 16, 2006, 02:05:23 PM
Use an open mesh floor and you'll ahve no problems. The open mesh stops any condensation forming.

Adam