I have a nephew who works with SS who can make me the internals of an extractor out of "scrap" ;) Because he is interstate I will have to source/make the rest. I just need some measurements to get started - can someone tell me the diameter of the internal basket and the outside drum for a 8/9 deep frame radial extractor?
Thanks
my extractor is from quality and it is 1050mm od
I thought the SS was disbanded in May 1945?
stainless steel
Quote from: Rooky25 on February 07, 2015, 09:08:04 PM
my extractor is from quality and it is 1050mm od
Thanks - nearly done - grossly over engineered. Much bigger than I was expecting mainly due to the fact I wanted to run the honey straight into a 20 L drum through a double strainer so made it high enough for it to fit under. Will post some pic when done Also working on a not so portable crane to lift full supers off the hive
Sounds cool - looking forward to the photos.
About the crane, you've no doubt thought of this, but what about making one that can mount on a ute or tractor?