converting hand crank extractor to motorized. I finally did it

Started by ronwhite3030, March 30, 2011, 10:14:19 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

ronwhite3030

<object width="425" height="344"><param name="movie" value="http://www.youtube.com/v/lve2-4WSeLo?hl=en&fs=1"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/lve2-4WSeLo?hl=en&fs=1" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="425" height="344"></embed></object>


Thanks to everyone who answered my questions.

BlueBee

Good job Ron.

I like your spring tensioner idea.  So it looks like you're using a permanent magnet DC motor.  Is that from the tread mill?  Are you using the tread mill controls for speed control?

ronwhite3030

Thanks Bluebee, I thought the spring tensioner would be the simplest and achieve my goal, and yes I am using motor and the controls from the treadmill, It cost me $25.00 for the treadmill and $50.00 for a machine shop to mill down the shaft to 1/2" and machine the hub that is set into the pulley on the extractor so $75.00 to make it happen, which is much cheaper then the $400.00 conversion kit from the manufacturer in Italy.